INDUCTION TYPE DIRECTIONAL OVER CURRENT RELAY

The directional power relay is not suitable under short circuit conditions because as short circuit occurs the system voltage falls to a low value resulting in insufficient torque to cause relay operations. This difficulty is overcome in the directional over current relay, which is independent of system voltage and power factor.

Constructional details: – Figure shows the constructional details of a typical induction type directional over current relay. It consists of two relay elements mounted on a common case viz. (i) directional element and (ii) non-directional element.

(i) Directional element: It is essentially a directional power relay, which operates when power flows in a specific direction. The potential of this element is connected through a potential transformer (PT.) to the system voltage. The current coil of the element is energized through a CT by the circuit current. This winding is carried over the upper magnet of the non-directional element. The trip contacts (1 and 2) of the directional element are connected in series with secondary circuit of the over current element. The latter element cannot start to operate until its secondary circuit is completed. In other words, the directional element must first operate (ie. contacts 1 and 2 should close) in order to operate the over current element.

(ii) Non-directional element: – It is an over current element similar in all respects to a non-directional over current relay. The spindle of the disc of this element carries a moving contact which closes the fixed contact after the operation of directional element. Plug setting bridge is provided for current setting. The tappings are provided on the upper magnet of over current element and are connected to the bridge.

Operation:- Under normal operating conditions, power flows in the normal direction in the circuit operated by the relay. Therefore, directional power relay does not operate, thereby keeping the (lower element) un-energized. However, when a short circuit occurs, there is a tendency for the current or power to flow in the reverse direction. The disc of the upper element rotates to bridge the fixed contacts 1 and 2. This completes the circuit for over current element. The disc of this element rotates and the moving contact attached to closes the trip circuit. This operates the circuit breaker which isolates the faulty section.

Written by John on March 23rd, 2009 with 5 comments.
Read more articles on classification of relays and Power System and Relays and Switchgear&Protection.

Related articles

• INDUCTION TYPE DIRECTIONAL POWER RELAY (March 23rd, 2009)
• OVER LOAD INVERSE-TIME / INVERSE DEFINITE MINIMUM TIME LAG (I.D.M.T.) RELAY (March 17th, 2009)
• STATIC DISTANCE RELAY (March 17th, 2009)
• STATIC DIFFERENTIAL RELAY (March 17th, 2009)
• STATIC DIRECTIONAL RELAY (March 17th, 2009)